BJ-256 BJ Control Pro
User Guide
BJ-256 BJ Control Pro
Page 16
c)
To record telephone keys only
, enter the
code 602
. This code affects the
entire level. When you enter the code 602, each cell on the remote in the
selected level will be programmed with the following RF codes:
Codes 100-112 = numerical keys on the BJ telephone
Code 110 = pick up and hang up
If you press the key with code 101, number 1 on the
BJ telephone will be dialled, and so on.
4
Scanning types
This section describes the different types of scanning that can be configured on the
remote when used in "sequential control" mode.
It is a good idea to select the type of scanning that suits you because this can
make it significantly easier to use the cells on the remote.
Type 1: cell-to-cell scanning
a)
Connect the switch to the control input (Figure 2).
b)
To enable scanning, press the switch. The different cells will be highlighted
sequentially, one by one.
c)
Press the switch again to activate the cell whose LED is lit at that moment.
Type 2: scanning by rows and columns
a)
Connect a switch to the control input (Figure 2).
b)
To enable scanning by rows, press the switch. The different rows of the
remote will be highlighted sequentially, one by one.
c)
To select a row, press the switch again. Each of the cells in that row will
then be highlighted sequentially (scanning by columns within the selected
row).
d)
Press the switch again to activate the cell whose LED is lit at that moment.
101
ESC
104
107
111
110
102
105
108
100
103
106
109
112
110
Summary of Contents for BJ CONTROL PRO
Page 24: ......
