BJ-256 BJ Control Pro
User Guide
BJ-256 BJ Control Pro
Page 13
5.
Record the infrared signal on the Control Pro
a)
Point the remote control that you
wish to duplicate at the "infrared
recording" port (see Figure 2) of the
Control Pro and press the button on the
remote that you wish to duplicate.
b)
When the Control Pro has stored the
function of the other remote, the battery
LED will switch itself off, indicating that
programming has ended.
Code 400:
When this code is used to record infrared signals instead of code 000,
the device will perform the programmed action for as long as the key is pressed.
For example, if the action recorded is "turn up the volume on the television," if
code 000 was used, when you press the button where the signal was recorded, the
volume on the television will be turned up one level. However, if you used code
400, the remote continues the action, so the volume will continue to rise until you
release the button.
Code 500:
This code is used for the dual recording of the infrared signal. This is a
useful feature because the infrared signal emitted by some consumer devices can
change even when the same button is pressed (e.g. the same button switches the
television "on" and "off"). With this code, you can record the different signals
emitted by the device to resolve situations where the recorded action would
otherwise only work half of the time.
To begin, record the first press of the button on the remote control you wish to
copy using code
000
and then record the second time it is pressed using code
500
.
Check that they were recorded correctly; if not, repeat the process until they are
recorded correctly. If after five attempts you have not managed it, contact your
dealer as it may be possible that the two remotes are incompatible.
1
4
7
*
2
5
8
0
X
3
6
9
#
ESC
1
4
7
*
2
5
8
0
X
3
6
9
#
ESC
Summary of Contents for BJ CONTROL PRO
Page 24: ......
