Rev. 1.01
- 16 -
SRP-350IIOBE
1-9 Connecting the Power Supply
※
CAUTIONS
When connecting or disconnecting the power supply from the printer, make sure that the
power supply is not plugged into an electrical outlet. Otherwise you may damage the
power supply or the printer.
If the power supply’s rated voltage and your outlet’s voltage do not match, contact your
dealer for assistance. Do not plug in the power cord. Otherwise, you may damage the
power supply or the printer.
1-9-
1 Make sure that the printer’s power switch is turned off, and the power supply’s power
cord is unplugged from the electrical outlet.
1-9-2 Check the label on the power supply to make sure that the voltage required by the
power supply matches that of your electrical outlet.
1-9-
3 Plug in the power supply’s cable as shown below. Notice that the flat side of the plug
faces down.
※
NOTE
To remove the DC cable connector, make sure that the power supply’s power cord is
unplugged; then grasp the connector at the arrow and pull it straight out.
