You should check your vacuum cleaner’s Rotating
Floor Brush and Drive Belt regularly for wear or
damage. You should also clean the brush and brush
ends of strings, hair, and carpet fibers. These can
wrap around the brush and hamper its ability to
effectively clean your carpet. Also remove any debris
that has accumulated under the brush cover.
Unplug cleaner from electrical outlet.
Place handle in Low position and turn vacuum cleaner over
so bottom side is up.
Lift tab 1 and release the three latches in order 2-4 as
marked. Lift the Brush Cover off.
Grasp Rotating Floor Brush at both ends and lift.
Clean strings, hair and other debris from Rotating Floor
Brush, paying particular attention to brush ends.
Clean strings, hair and other debris from Motor Pulley and
Drive Belt areas.
Check Drive Belt carefully for wear, cuts or stressed areas.
Check Air Passageway for obstructions. Remove debris
from this area.
Use only BISSELL Style 12 Replacement Belts (#32074)
in your BISSELL PowerForce Turbo Bagless.
Unplug cleaner from electrical outlet.
With Rotating Floor Brush removed from vacuum cleaner
(Steps 1-4 of Check Rotating Floor Brush and Drive Belt),
grasp old Drive Belt and remove from Motor Pulley. Discard
old Drive Belt.
Place new Drive Belt over Motor Pulley and stretch other
end over Rotating Floor Brush in the space between
the bristles.
Place ends of Rotating Floor Brush down into slots on sides
as shown.
Turn Rotating Floor Brush by hand several times in the
direction of Motor Pulley. If properly installed, Drive Belt will
center itself on Rotating Brush.
Reposition Brush Cover and snap back into place. Check to
be sure all three latches are secured.
1.
Check Rotating Floor Brush and Drive Belt
10
2.
3.
4.
5.
6.
7.
8.
Replace Drive Belt
1.
2.
3.
4.
5.
6.
4
Air Passageway
Motor Pulley
ug203-2829_6596_1105.indd 10
ug203-2829_6596_1105.indd 10
1/11/06 4:03:39 PM
1/11/06 4:03:39 PM
