www.BISSELL.com
9
To remove the Battery
Cover, hold the Invisible
Wall and press firmly
while sliding downward to
remove the Battery Cover.
Insert batteries with the
+/- terminals facing the
directions indicated and
replace the Battery Cover.
(AA batteries not included)
To turn ON the Invisible
Wall, slide the switch away
from the light towards
the “I” symbol. Wait 10
seconds between turning
it ON or OFF.
The Invisible Wall is used to block
your robot from entering or leaving a
room. Place the Invisible Wall in front
of a room that you intend to block
and do not want the robot to clean.
The Invisible Wall
*
: Assembly & Use
NOTE:
Indicator light is only ON when robot
approaches sensor path.
TIP:
If the robot strays too far away from
the Docking Station, it may not return
automatically. Use the Invisible Wall to keep the
robot within range of the docking station.
TIP:
Run time and performance may vary
based on the amount of debris present. Use
the Invisible Wall to limit the allowed range in
messier rooms.
*Requires 4AA batteries. Batteries sold separately
Maintenance
To keep your SmartClean Connected robot running at peak performance, the following care
and maintenance is recommended:
Robot Part
Care Frequency
Replacement Frequency
Dust Bin
After each use, see page 10
As needed
Dust Bin Filter
Once per week, see page 10
Every 2-3 months
Brush Roll
Once per week, see page 11
As needed
Sensors
Once per month, see page 12
Not required
Edge Cleaning Brushes
Every 2-3 months, see page 12
Every 6-12 months
WARNING
To reduce the risk of electric shock, turn Power Switch OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting checks.
1
2
3
4
