of rotary device on both sides of the hexagonal shaft with boltsM8×55.
Attention: there are blade units on both sides; make sure the blade
cutting edge works firstly when the tiller runs. After the rotary blades
are installed, you must install the safety panel to prevent injures by
blades. Tilling depth can be adjusted through adjusting shift lever and
its included angle with the ground.(refer to table 4)
2. Rotary tillage of paddy field: when the depth of paddy field is below
25cm, you can go tilling with curved blades of paddy field directly.
When the depth of paddy field is between 25-45 cm, you can go tilling
with rotary wheels of paddy field. table 4
3. When ditching, you should take down shift lever, install the ditcher and
adjust its depth and height. After finishing these, you can do ditching
work.(look at picture3)
Range of ditching scope: 14cm-40cm
Range of ditching depth: 11cm-25cm
4. Short-distance transportation
Install forearm of tiller case on the drug bar of running gear and install
wheels on the driving shift of the running gear. After finishing these,
you can transport. The rated load is 250kg. Under the rated rotary
speed of gasoline engine, the fast speed is around 10km/h and slow
speed 5km/h.
5. Multifunctional work
Take away safety cover behind gear box, bolts behind main shaft, take
key sleeve
of shaft, push the belt pulley or key slot of coupling into the
key, then fasten it with bolt. V-belt A-model is used for the cross
section of belt pulley slot. The rated rotary speed of belt pulley is
3000r/m. when it is attached with relative machine tools, you can carry
www.italiastar.ro
004/021.433.03.27
Italia Star Com Due S.R.L.
103
