Make sure to ground the unit (Take earth).
Make sure to install the power supply with an earth leakage
breaker (Magnet Contactor)
Carefully read and fully understand this manual before use.
<
Pre-Operation Check
>
1. This lift is designed for motor vehicle servicing. DO NOT Use for other purpose.
2. Coating, consumable parts, and the like are outside the scope of the warranty. When
corrosion or wearing occurs, apply repair coating or replace the parts.
3. DO NOT attempt to lift heavier loads than its rated capacity.(3500 or 4000 kgs.)
4. If any of safety device does not operate properly, DO NOT use lift.
5. Use only genuine supports to lift vehicle (Side Sill Block for FP3500X and 4000X).
6. Position vehicle for the correct lifting point of Upper Scissor lift (FP3500X and
FP4000X). If vehicle lifting points can not be positively identified, DO NOT lift the
vehicle. For the correct lifting points, refer to maintenance manual of the vehicle.
<Lift-Up/Down Operation>
1. When operating the lift, pay constant attention to the area around the vehicle and the
lift. NEVER look aside during operation.
2. DO NOT lift vehicles with passengers or baggage inside.
3. When the Upper Scissors lift come into contact with the vehicle during lift-up, make
a halt and ensure that Top Plates (Free Wheel Stand) of Upper Scissor Lift are in
proper contact.
4. DO NOT approach or touch the vehicle or the moving parts of the lift during lifting.
5. DO NOT operate the lift with anything such as tools or parts left in the posts or
under the lift. Failure to comply may result in failure of the lift or falling of
the vehicle.
6. Before lowering the lift, ensure that no person or objects is around vehicle or lift.
7. Only after the Upper Scissor Lift and lower lift are completely down, drive the
vehicle onto or out from the lift.
8. DO NOT use the lift if the hydraulic pressure is released from the cylinder after
lowering the lift with the Lowering Stop Hook engaged.
<During Work>
1. Make sure Safety Hooks are engaged before getting under vehicle.
2. When working on a vehicle in raised position, make sure the lift is above the position
that Safety Hook is engaged at least with 1st ratchet (Cut out) from the bottom.
The lift may drift down (Natural Lowering), causing damage to the vehicle or equipment,
tools, or the like nearby.
3. Keep anyone but the operator out from around the lift.
4. DO NOT leave a vehicle on the lift for long time.
5. When not in use, the lift must be lowered to the lowest position. Even when not in use,
raise and lower the lift all the way through the range at least once a day to maximize
it's life.
<Others>
1. DO NOT modify the lift without permission from the manufacturer. Failure to comply
may result in insufficient performance and lead to serious accident.
2. When an abnormality is detected during use or inspection, stop the use of the lift
immediately and repair. DO NOT use lift until the repair is completed.
- 5 -
