1) Remove any load or vehicle from Drive-On
Beams
2) Raise Drive-On Beams about 50cm and put
a wooden block under End Beam A.
3) Lower Drive-On Beams and stop lowering
operation when End Beam A is blocked by
wooden block. After End Beam A hit the
wooden block, chain become slacking and
can check if Safety Hook is engaged to
Ratchet (Rack). If Safety Hook is engaged,
it is functioning.
1) Remove any load or vehicle from Drive-On Beams
2) Lower the Drive-On Beams to the bottom
3) Raise Drive-On Beams and check if all Safety Hooks make clicking sound. If they make clicking
sound, they are functioning.
1) Remove any load or vehicle from the
Drive-On Beams
2) Raise the Drive-On Beams a little bit
and put 4 wooden blocks under End Beams.
3) Lower Drive-On Beams to contact the
wooden blocks and stop the lowering
⇒
operation when Wire Rope become
slackening. If Catch Gear turns and
contact Safety Bar, they are
functioning.
1) Remove the load from Support Plate.
2) Raise the Upper Scissors Lift to the highest position.
3) Push the Control Lever to "Down" position without releasing Safety Hooks. If Safety Hooks become
engaged to Ratchet (Rack) and Upper Scissor lifts do not lower, Safety Hooks are functioning.
-20 -
(Rack)
(Rack)
Safety
Bar
Catch
Safety
Bar
End
Catch
Gear
End
Replace Wire Ropes (Cables) at least every 2 years
.
Warning
Replace Safety Bar and Catch Gear in the event of Wire Rope (Cable) breakage as Safety Bar may
be bent and Catch Gear could be damaged.
Caution
DO NOT stop raising Wheel Free (Upper Scissors) lift in the middle of its rising travel to work on
the vehicle. Safety Hook does not engage to Ratchet (Rack) in the middle of rising travel.
Caution
Wooden Block
