BIRO EMG-32, Operating Manual And Parts List

Page: 5 / 40

INSTALLATION
TO AVOID SERIOUS PERSONAL INJURY, PROPERLY INSTALL
EQUIPMENT IN ADEQUATE WORK AREA
3
• ALWAYS Connect to Proper Voltage & Phase.
• NEVER
Operate Machine With Product Mixer Safety Cover Open or Removed or Magnetic
Interlock Switch By-Passed.
• ALWAYS
Use Qualified Technician and Electrician for Installation.
• ALWAYS Install Equipment in Work Area with Adequate Light and Space Away From Children
and Visitors.
• ONLY Operate on a Solid, Level, Non-Skid Surface.
• ALWAYS Lock Machine Castors After Moving Machine to Operating Location.
• NEVER Bypass, Alter, or Modify This Equipment in Any Way From Its Original Condition.
• NEVER Operate Without all Warning Labels Attached and Owner/Operator Manual Available to
the Operator.
• USE ONLY
BIRO Parts and Accessories Properly Installed.
UNCRATING AND SET UP
1. Read this Manual thoroughly before installation and operation. Do not proceed with installation and
operation if you have any questions or do not understand anything in this Manual. Contact your local
Distributor, or BIRO
first
.
2. After removing shipping carton, all banding, and all equipment from inside the tub.
Remove screws from cradle structure, remove cradle structure from under machine. Fold down hinged
ramp, unlock casters, and carefully roll machine off of pallet.
3. This machine is shipped with the adjustable legs fully retracted. The legs allow for a height adjustment
from the floor to centerline of bowl 32” minimum to 38” maximum.
4. This machine weighs approximately 730 pounds. To avoid accidents block up and support machine after
raising to desired operating height.
5. The adjustable legs can be unbolted and lowered to the floor. Replace bolts and nuts and tighten securely.
To the nearest adjustment height, confirming all legs are of equal height.
6. Install machine on a level, non-skid surface in a well-lighted work area away from children and visitors.
7. This machine is complete except for knife and plate. There is a bowl shipping plug (cardboard)
placed in the output end of the grinding bowl to retain the grinding auger during shipment. REMOVE
THE BOWL SHIPPING PLUG AND THE GRINDING AUGER.
8. After checking and making sure the power supply is correct, plug in your machine. NEVER OPERATE
MACHINE WITH PRODUCT MIXER SAFETY COVER OPEN. (Machine will not run with cover
open.) ROTATION MUST ONLY BE CHECKED WITH THE GRINDING AUGER REMOVED,
otherwise serious irreparable damage may occur to the grinding components.
9. Machine must be properly grounded. Use qualified electrician to install according to local building codes.