INSTALLATION
TO AVOID SERIOUS PERSONAL INJURY
PROPERLY INSTALL EQUIPMENT IN ADEQUATE WORK AREA
UNCRATING AND SET UP
1. Read this Manual thoroughly before installation and operation.
Do not
proceed with installation and
operation if you have any questions or do not understand anything in this Manual. Contact your local
Distributor, or BIRO
first.
2. Install machine on a level, solid, non-skid surface in a well-lighted work area away from children
and visitors.
3
ALWAYS
Install Equipment in Work Area with Adequate Light and Space Away From Children and Visitors.
ALWAYS
Use Qualified Technician and Electrician for Installation.
ALWAYS
Connect to
Proper
Voltage & Phase.
ONLY
Operate on a Solid, Level, Non-Skid Surface.
NEVER
Bypass, Alter, or Modify This Equipment in Any Way From Its Original Condition.
NEVER
Operate With Tray Removed.
NEVER
Operate Without all Warning Labels Attached and Owner/Operator Manual Available to
the Operator.
3. This machine is complete
except
for a knife and plate. The grinding bowl assembly is packed separately
in the crate. Remove the grinding bowl assembly from the carton. Disassemble the grinding bowl assembly.
Assemble the grinding bowl only, onto the front of the grinder. Install the bowl lock handle assembly into
the frame under the grinding bowl. Securing the bowl. The back flange of the grinding bowl should be tight
against the front of the machine. Do not install grinding worm at this time.
4. Install the feed tray to the top of the grinder. After checking and making sure the power supply is correct,
plug in your machine.
NEVER OPERATE MACHINE WITHOUT TRAY INSTALLED.
5. Machine must be properly grounded. Use qualified electrician to install according to building codes.
6. A toggle switch is located on the motor junction box.
7. Push the toggle switch to “ON” position.
CHECK THE ROTATION OF THE WORM DRIVE SHAFT.
ROTATION MUST BE COUNTER-CLOCKWISE
as indicated by the rotation decal affixed to the
grinding bowl.
ROTATION MUST ONLY BE CHECKED WITH THE GRINDING WORM
REMOVED,
otherwise serious irreparable damage may occur to grinding components. Push toggle switch
to “OFF” position.
