9
2
INSTALLATION
2.1.
PRECAUTIONS BEFORE INSTALLATION
This device is designed and engineered for easy integration into existing water
systems. However, having the following tools and supplies in hand will be greatly
helpful to the installation:
• Screwdriver
• Drill bit
• Tape measure
• Pipe wrench
• Adjustable wrench
Ensure that the line voltage corresponds to the stated voltage on the unit’s
specification label. Make sure that the plug on the power cord from the product
and the outlet are matched. For proper operation, and to ensure the best
performance of application from the product, make sure that the system is not
connected to a switched electrical outlet.
Electrical
Plumbing
- For best performance, use cold tap water and filter the input water to 1µm.
- Ensure adequate back-flow protection is provided to comply with all national
and local standards and codes.
- Do NOT over-tighten the connections. It is recommended that plastic fittings be
used when connecting to the plastic connections of the product. This will
reduce
the possibility of cracking the connections due to over-tightening.
The use of
union (O-ring seal) connections is highly recommended for ease of
installation
and future servicing.
If any parts are damaged, contact your supplier IMMEDIATELY.
Do NOT install damaged parts.
- For safety, run water pressure under 7 kg/cm
2
(100 psi). To reduce water
pressure, install a water pressure regulator and set water pressure to suit
application.
