Biosan UVR-M, User Instructions

Page: 9 / 12

9
7. Ordering information
7.1 Models and versions available:
Model Version Description Catalogue number
UVR-M
V.4AA 230 V, 50 Hz, EU plug (type E/F)
BS-040105-AAA
V.4AB 230 V, 50 Hz, UK plug (type G)
V.4A3 230 V, 50 Hz, AUS plug (type I)
V.4AC 120 V, 60 Hz, US plug (type B)
UVR-Mi
V.3AA 230 V, 50 Hz, EU plug (type E/F)
BS-040110-AAA V.3AB 230 V, 50 Hz, UK plug (type G)
V.3A3 230 V, 50 Hz, AUS plug (type I)
7.2 To inquire about or order the optional accessories, contact Biosan or your local Bio-
san representative.
7.3 Optional accessories:
Optional accessory Catalogue number
UVR-S movable support stand BS-040105-AK
8. Care and maintenance
8.1 Service .
8.1.1 If the unit is disabled (e.g., lamp or fans not working, no reaction to key presses, etc)
or requires maintenance, disconnect the unit from the mains and contact Biosan or
your local Biosan representative.
8.1.2 All maintenance and repair operations (except listed below) must be performed only
by qualified and specially trained personnel.
8.1.3 Operating integrity check. If the unit follow the procedure described in section 5. Op-
eration , then no additional checks are required.
8.2 Cleaning and disinfection .
8.2.1 Use mild soap and water with a soft cloth or sponge for cleaning the exterior. Rinse
remaining washing solution with distilled water. Wipe dry the excess water with clean,
soft cloth or sponge.
8.2.2 Dust filter control/replacement. The dust filters on either end of the UV-recirculator
should be checked monthly and cleaned or replaced when they become clogged. To
check, replace or clean the filters, simply unclip the covers (fig. 4/

and 5/

), if nec-
essary, fit a new one; otherwise rinse in water, dry, and set up existing filters. Clip
covers back in place.
8.2.3 To disinfect the exterior plastic parts, use 75% ethanol or DNA/RNA removing solution
(e.g., Biosan PDS-250 ). After disinfecting it is necessary to wipe the surfaces dry.
8.2.4 Cleaning of the interior. Cleaning of the interior must be performed only by qualified
and specially trained personnel. In order to ensure proper efficiency in the long run,
it is recommended to clean the UV-recirculator once a month.
8.2.5 The unit and its accessories are not autoclavable.