BIOS Professional 200TC, Instruction Manual, Page: 9 / 44

8. Repeat steps 4-7 to register remaining sensors.
9. Once registration is completed, press and hold
MODE/SET to exit registration
mode.
*Press and hold or arrow for fast increment and decrement movement.
NOTE: If at any time the monitor goes back to normal mode, follow steps 1
and 2 to get back to registration mode.
Once registering is complete, ensure monitor and sensor are in an upright
position (see section 11.0 for wall-mount instructions).
7.0 Deleting a Registration
Sensors will need to be de-registered if they are no longer required, or if they will
be used for a location different than that which it was previously programmed for.
IMPORTANT:
Both the monitor and sensor will need to be de-registered.
1. In registration mode (refer to section 6.0 steps 1-2), press and hold both
arrows on the monitor ( ) for 2 seconds to activate the de-registration
function. Digits on the first row will flash.
2. Press or to select the sensor to be de-registered. The digits of that
selected sensor will flash. Press MODE/SET to confirm, numbers will turn
into dashes.
Sensor has been
de-registered
3. Once de-registration is complete, press and hold both arrows ( )
to return to registration mode OR press and hold
MODE/SET to return to
normal mode.
4. To de-register the sensor, remove 1 battery from the sensor.
5. While pressing the
MUTE/SLEEP button on the front of the sensor, insert the
battery back into the battery compartment. You will hear a beep. Continue to
hold the MUTE/SLEEP button while the beep sounds. Let go of button
after beep stops.
6. You will then see (- -) in the sensor display instead of a sensor number. When
the dashes are displayed the sensor has been de-registered successfully.
NOTE: If you are not going to re-register a sensor, remove all batteries.
Sensor will then be ready for registration when required.