BIOS Professional 200TC, Instruction Manual, Page: 8 / 44

5.0 Using an Extension Cord
An extension cord can be used if the cord on the probe is not long enough to
reach the desired area from where the sensor is mounted.
1. Plug extension cord into temperature sensor.
2. Plug probe into extension cord.
3. Use the slide extension ON/OFF switch to select Ext. ON.
NOTE:
If an extension cord is added after the sensor is registered, reset the
sensor by removing and re-inserting one battery.
6.0 Registering Temperature Sensors to Monitor
By registering each sensor to the monitor, you ensure that no cross
communication will occur. Each sensor will act independently to communicate its
temperature to the monitor.
NOTE:
Ensure probe is fully inserted in sensor before registering. If using
extension cord, ensure cord is inserted in sensor and probe is inserted in the
extension cord. Remove the back panel (using the screwdriver provided) from all
sensors that will be registered before starting registration.
1. Press
MODE/SET once on the monitor, the REG icon (
) will appear.
2. Press and hold MODE/SET to enter registration mode. You will hear a beep
once it is confirmed.
3. The current sensor number and dashes (--.-) will flash on the monitor.
4. Insert 3 x AAA batteries into the back of the sensor.
NOTE: If no temperature sensor is registered within 1 minute the monitor will
go back to normal mode.
5. Once the batteries are inserted into the sensor you will hear a long beep from
the sensor. If registration was successful, a number will appear on the LCD
screen of the sensor. This number is the number of the sensor (see section
13.0 Troubleshooting if a number is not displayed).
6. Once the sensor is registered, the current temperature will be displayed
on the monitor and the SET MAX temperature will flash. Use the and
arrows to adjust the maximum temperature limit.* Press MODE/SET to
confirm.
7. The SET MIN temperature will begin to flash. Use the and arrows to
adjust the minimum temperature limit.* Press
MODE/SET to confirm.
ALARM ALARM
Probe not fully
inserted
Probe fully
inserted
ALARM ALARM
Registered Not Registered