BIOS AP DVT10U3, User Manual

Page: 15 / 62

DVT10U3
－
12
－
「
Parameter Confirmation
」
section to read its value.

Disk Size Setup
DISK Size
xxB
Disk size will not be automatically detected and should be manually configured. The size will be applied to
all drives. Actual disk capacities should be larger than its configured size.
A bigger drive size than supported listing will be added in future firmware upgrade. Please check our website
for new firmware.
Parameter Function Memo
Test 1GB Set DISK Size as 1GB (Test only)
1TB, 2TB, 3TB, 4TB,
5TB, 6TB, 7TB, 8TB Set Disk Size as the number
● Please do not change the default setting
If actual drive size was smaller than setup value, error such as
「
ONE
DOWN L
」
,
「
SYSTEM DOWN L
」
will occur and buzzer will be fired.

RAID Mode Setup
RAID MODE
RAID-6
RAID mode selection, supported RAID MODEs are
RAID 6, RAID 5, RAID 3, RAID 0, RAID 10
RAID10 works as a pair of
‘Drive 0, 1’ ‘Drive 2, 3’, ‘Drive 4, 5’ etc.

DRIVE Mode Setup
DRIVE MODE
10*
Number of drives to install
For RAID 0, 6, please leave it as default
“10” drives. If you wanted to change, only
even number of drives
is supported.
For RAID 3, 5, only odd number of drives can be installed and applied, please choose
“9” for maximum
capacities.
For RAID 10, only 8 drives can be applied
Note: For ten drives USB3.1 model, factory default and suggestion is always RAID 6 with 10 drives.
CAUTION
M