Er1 -
The inserted test strip has been used or damaged. Please use a new test
strip.
Er2 -
The meter has malfunctioned. Do a Quality Control Test or reinstall the
battery to check if the meter works properly.
Er3 -
The signal transmission is disrupted. Repeat the test using a new test strip.
Er4 -
The blood sample volume is insufficient. Repeat the test using a new test
strip.
Er5 -
An issue calibrating the Meter has occurred. Please follow the steps below:
(1) Remove the test strip from the meter.
(2) Turn off the meter (press and hold the Main button for 3 seconds).
(3) Press the main button to turn ON the meter.
If after turning on the Meter, you do not see Er5, your meter is functioning
properly and able to perform a test.
If one of the above error messages still appears, please contact Bionime
Customer Service.
Error Messages and Troubleshooting
Meter Malfunction
If the RIGHTEST Blood Glucose Meter GM280B will not turn on, please follow the steps below:
1. Open the battery cover and remove the battery.
2. Wait for 5 minutes and reinsert the battery as described.
The meter should work normally after finishing the above steps. If the meter still does not work,
please contact your local
customer service.
Bionime
Strip Error
1. When the test strip is inserted incorrectly, the meter will beep 3 times while the
" " symbol flashes. Do not apply a sample on the test strip. Please re-
insert the unused test strip correctly.
2. If, after performing the required steps, the
and flashing
" "
" "
symbols appear on the screen, it means the
Blood Glucose Test
RIGHTEST
Strip GS280 has been inserted incorrectly more than twice. Please, re-insert
the unused test strip again or call Customer Service for support. This error
message can also indicate that you may have used the wrong test strips.
Please check the test strip vial to ensure you are using the
Blood
RIGHTEST
Glucose Test Strip GS280.
Sampling Error
Please do not apply the blood to the sample port of the test strip before the
meter displays " ". Discard the test strip If the meter shows " ".
Battery Error
1. The " "
symbol blinks when the battery power is low. Please
change the battery as soon as possible. You can still perform the test.
2. The " " and " " symbols blink when the battery power is too
low. Meter cannot test. Please change the battery immediately.
Error Messages and Troubleshooting
55
54
Summary of Contents for RIGHTEST GM280B
Page 2: ......
