Bionet Oxy9Wave Vet, Operation Manual

Page: 9 / 48

Oxy9Wave Vet
Operation manual
Ver. 1.52 1.SAFETY INFORMATION 9
⚫
Electric shock hazard: Do not open the pulse oximeter cover except to replace the battery
of the Handheld unit. Only a qualified operator may perform the maintenance procedures
specifically described in this manual. Refer the servicing to Bionet for repair of this
equipment.
⚫
As with all medical equipment, carefully route the patient cabling to reduce the possibility
of patient entanglement or strangulation.
⚫
Do not place the pulse oximeter or accessories in a place that may cause it to fall on the
patient. Do not lift pulse oximeter by the power cord or any other cable.
⚫
Do not use the pulse oximeter or oximetry sensors during magnetic resonance
imaging(MRI) scanning. Induced current could potentially cause burns. The pulse oximeter
may affect the MRI image, and the MRI unit may affect the accuracy of the oximetry
measurements.
⚫
When using pulse oximetry during full body irradiation, keep the sensor out of the
irradiation field. If the sensor is exposed the irradiation, the reading may be inaccurate or
the unit may read zero for the duration of the active irradiation period.
⚫
Do not place the pulse oximeter on electrical equipment, which may affect the pulse
oximeter and prevent it from working properly.
⚫
Do not expose the pulse oximeter to excessive moisture such as direct exposure to rain
(excessive moisture can cause the pulse oximeter to perform inaccurately or fail).
⚫
Do not place containers with liquids on or near the pulse oximeter
(liquids spilled on the pulse oximeter may cause it to perform inaccurately or fail).
⚫
Failure of Operation – If the pulse oximeter fails any part of the setup procedures or leak
tests, discontinue the operation of the pulse oximeter until qualified service personnel
have corrected the situation.
⚫
Patient Safety – If a sensor is damaged in any way, discontinue use immediately.
⚫
In case the equipment does not operate as usual, or It is damaged, do not use on the
patient; contact the equipment supply division.