Bionet Oxy9Wave Vet, Operation Manual

Page: 24 / 48

Oxy9Wave Vet
Operation manual
Ver. 1.52 4.Operation 24
4-3. Basic operation
4-3-1. Introduction
To operate the Oxy9Wave Vet Pulse Oximeter effectively, the device must be set up properly, and
the operator must:
⚫
Know how the pulse oximeter derives its readings.
⚫
Familiarize himself/herself with its controls, components, and operation.
⚫
Understand its status and the alarm messages.
4-3-2. Basic Setup
[ GENERAL SETUP AND USE ]
1. Check whether the case is damaged.
2. Connect the cable and connector and check whether the lines are twisted or a corner is worn
out.
3. Connect the power cord and turn on the power.
4. Check whether the SpO ₂ sensor is the one we approved and provided and remove objects
that can interfere with the transmission of light between the light source and the photo
detector.
5. Press the power button.
6. Attach the sensor to the hand or foot of the patient.
7. Check the following on the screen :
⚫
%SpO ₂ , max/min alarm value of BPM
⚫
%SpO ₂ , and value of BPM
NOTE
: If it is displayed as a bar rather than as a value, please wait about 10 seconds.
8. You can set the volume of Pulse beep and alarm.
⚫
When the value exceeds the designated range, the alarm rings, and the color is changed.
9. Check the status of the sensor (message).
⚫
“ Check Probe ” (not connected to patient) is displayed in the message zone.
⚫
“ Lead Fault ” (sensor is not connected) is displayed in the message zone.
⚫
“ Artifact signal ” (sensor is moving too fast) is displayed in the message zone.
10. Alarm Silence
⚫
Button to stop the alarm that sounds when the designated range is exceeded.
⚫
Press the Alarm Silence button.
⚫
The alarm will stop during the designated period.
11. Monitor the patient.