Biolase Waterlase iPlus, User Manual

Page: 16 / 82

1 6
5
Equipment Description
Waterlase iPlus User Manual
Safety Features
Power deviations of more than 20% from the selected value will cause the display to show an
error message; the laser console will not operate until the system is reset by pressing the "Next"
arrow at the top of the touch screen. If the error message persists, please contact BIOLASE
Service or the authorized BIOLASE representative for your area.
FRONT AND BACK HANDLES
Use the front and back handles to move and/or lift the laser console when necessary.
CAUTION: Prior to lifting, make sure the handles are not damaged.
DO NOT use the Fiber Cable to pull the laser console; this could
damage the Fiber Cable and render the laser inoperable.
LOCKING WHEELS
Allow easy transport of the laser from operatory to operatory. Press down on the front tabs on the wheels
to lock the console. Lift up the tabs to release the locking mechanism.
EMERGENCY STOP
The red button located on the front panel of the laser console, instantly turns off the laser when pressed.
Safety Features
The button will glow red to indicate an emergency stop, and the control panel will display an error
message; press the button again to restart the system. The system will be in Standby mode when
turned back on, even if it was in Ready mode at the time the Emergency Stop was activated. Push
the Ready button before using the system.
KEYSWITCH
Use to switch the laser system ON by turning the key to the horizontal position; always use only the key
provided. The key cannot be removed while it is in the ON position. Always remove the key when the laser
is left unattended.
ENERGY MONITOR
The energy monitor measures and verifies power output .