BIOSUN-340_(Anglais) - DOC012466 - Ind. B03 - 21/06/2017
Copyright BIO-UV
Marque, Modèles et Brevets déposés - Produits exclusifs
Page 10
b.)
Assembly
b-1.
Foundations for the aluminium support structure
Pre-tighten the screws during the assembly period and firmly tighten only after assembling the whole structure
with its modules.
Risks of cuts
•
Cuts to the hands due to structural parts not deburred.
•
Wear safety gloves!
When the concrete foundation is completely dry, drill the attaching holes in the floor.
•
Using figure 01, measure and make marks on the concrete
•
Drill the concrete with a hammer drill using a 12 mm diameter drill bit.
b-2.
Assembling the aluminium support structure
b-2.1.
Mounting the base
For this step, you will need four anchoring studs, two narrow U formed sections (3 holes) and two wide U formed sections
(5 holes).
Before attaching, make sure you have properly positioned the wide U formed sections for the part pointing
towards the foundations pole and the narrow U formed sections for the part pointing towards the equator (see
Figure 01, red circles).
•
Fit the four anchoring bolts in the four holes drilled in step 2.1, and make sure to attach them the right way round!
•
Fit the U formed sections to the threaded rods (see figure 02) of the anchoring studs and then bolt the whole
assembly together.
Ä
The bolts are now attached in the holes.
Foundation
Concrete
foundation
U TYPE PROFILE
Clamping screw
Nut
Foundation