4.2 EDIT AND RUN A METHOD
The Edit selection of the Program mode allows you to change an existing method.
Table 5.
Procedure for Editing and Running a Method
Step
Procedure
Description
1.
Select
PROGRAM
from the
main menu.
2.
Select
EDIT
and the number
of the method to be edited.
3.
Select the constant parame-
ter for the step.
4.
Change the parameter
values, if desired.
5.
Change the programming
for a timed step.
6.
Edit the next step or quit
the editing function.
16
POWER
PAC
Program Mode Operation
This procedure assumes you have set up the unit as discussed
in Table 3, Preliminary Setup Procedure, at the beginning of this
chapter.
The Program menu lists the following: CREATE, EDIT, RUN,
and VIEW.
After you select
EDIT,
the list of available methods is displayed.
You must select either power, voltage, or current. The pro-
grammed constant parameter is highlighted.
Select the appropriate parameter, and enter its value using the
keypad. Note that the constant parameter is displayed on the
screen.
a. Select TIME or V-HOUR. The programmed parameter is high-
lighted.
b. Modify the value of the selected parameter:
• TIME: Duration may be from 1 to 99 hours 59 minutes.
• V-HOUR: From 1 to 99,999 V.
Select either of the following:
a. Select
ADD STEP
. If you are editing additional steps or adding
a step, repeat procedures 3 through 5 above.
b. Select
SAVE PROGRAM
.
MANUAL >>
PROGRAM >>
POWER FAIL DETECT
OFF
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
