User and service manual Stainer AUS124 from sn 101548475
Bio Optica Milano S.p.A.
via San Faustino 58
I-20134 Milano
Tel. +39 02.21.27.13.1
Fax Acquisti/39 02.21.54.155
Fax Assistenza/Contabilità +39 02.26.41.74.48
Fax V39 02.21.53.000
Revision 160804 of 04/08/16
Page 7 of 38
2) INSTALLATION
During the stainer moving, proceed cautiously in order to avoid possible damages.
Position the instrument on a level and stable working bench, free of vibrations. Make sure that on the upper part there is
space enough (ca. 30 cm) to allow the ascent/descent movements of the cover. Regulate the 4 rubber feet to get a
perfect horizontal position. Connect the instrument to the power supply socket (230V~ 50/60Hz) using the provided
cable.
Important:
Do not use any extension or adapter and do not modify the provided cable.
Respect the following working environmental conditions:
Room temperature between 10°C and 40°C.
Relative humidity between 30% and 75%.
Maximum temperature inlet water: 40°C.
3) WATER CONNECTIONS
Inlet running water
Connect the provided pipe (
10 mm) between the connecter placed on the left side of the instrument and a water tap.
Outlet running water
Connect the provided pipe (
18 mm) between the connecter placed on the left side of the instrument and the drain of
the laboratory.
Important:
As the draining happens by fall, it is necessary that the pipe is positioned as linear as possibile and
downhill (the water outlet connecter of the stainer must be situated over del water outlet connecter of the laboratory).
Connection between the two running water dishes and the instrument
Connect the two provided pipes (
10 mm) between the connecters of the running water dishes and
the
connecters
situated on the right side of the instrument. Choose the position of the dishes according to the main programme. Make
sure that
the
pipes are long enough to rotate the dishes holder disk.
