Installation
2
54
BinTec Access Networks GmbH
If you want to replace an expansion card, perform the following steps:
➤
Power down
X8500
if you want to exchange the system card or a X8E-2BC
expansion card.
➤
Loosen the screws of the card’s front panel (see
figure 2-8, page 51
arrows
no. 1).
Unplug the expansion card
➤
Press the switch on the injector/ejector handle in order to release the con-
nection linked to the cross section of the case front (see
figure 2-8,
page 51
, arrow no. 2).
The amber colored status LED is on (not for X8A-SYS, X8A-SYS-VPN or
X8E-2BC).
➤
Push the injector/ejector handle down until the expansion card comes out
of its position (see
figure 2-9, page 52
).
Caution!
Replacing the system card (X8A-SYS or X8A-SYS-VPN) or a
X8E-2BC expansion card while
X8500
is operating may cause
damage to
X8500
!
➤
While
X8500
is operating, only replace a PRI, G.703, DSP,
SYNC or E3 expansion card. The new expansion card must
be of the same type with the same licenses as the old one. It
must also have the same number of interfaces and modules!
➤
Power down
X8500
before exchanging the system card or a
X8E-2BC expansion card!
Caution!
Unplugging expansion cards which are not hot-swappable may
lead to damage of the device.
➤
Only draw the expansion card if the amber colored LED is on!
➤
Push the injector/ejector handle up again if the red, green and
amber colored LEDs are on!
This expansion card is not hot-swappable.
Summary of Contents for X5800
Page 4: ...4 BinTec Access Networks GmbH...
Page 34: ...34 BinTec Access Networks GmbH...
