X8500
Einbauanleitung / Installation Guide
49
Installing the Expansion Cards
2
For installation of expansion cards, perform the following steps:
➤
Make sure that
X8500
is powered down when installing the system card.
➤
Equip the system card with the internal Smart Media Flash Card (SMFC),
before you install the system card in
X8500
.
The SMFC provides the operation system software BOSS for
X8500
.
Please refer to
chapter 2.3, page 46
.
➤
Loosen the screws of the dummy front panel.
➤
Remove the dummy front panel.
Prepare the new expansion card
➤
Have the new expansion card ready for installation (take it out of the anti-
static bag).
Check if you require any additional installation on the expansion cards, like
for example the installation of resource module(s) (see
chapter 2.1,
page 39
) or the installation of BIANCA/BRICK communications modules
(see
chapter 2.2, page 45
).
The system card (X8A-SYS or X8A-SYS-VPN) must be installed
in the system card slot (fifth slots from the left). Slots 1 to 4 and 5
to 8 are provided for the expansion cards (for numbering of slots,
see chapter "
X8500
Basic Unit" in the
X8500
Hardware Installa-
tion Guide).
For optimal performance of
X8500
, slots 5 to 8 should be fully
equipped with expansion cards before slots 1 to 4 are used!
Please note that if you want to install the system card (X8A-SYS
or X8A-SYS-VPN), you first have to equip it with the internal
Smart Media Flash Card (SMFC) as described in
chapter 2.3,
page 46
!
Summary of Contents for X5800
Page 4: ...4 BinTec Access Networks GmbH...
Page 34: ...34 BinTec Access Networks GmbH...
