Installation
2
50
BinTec Access Networks GmbH
Plug in the expansion card
➤
Insert the expansion card into the selected slot until the red status LED is
on (not for X8A-SYS or X8A-SYS-VPN).
➤
Push the expansion card further until the amber colored status LED is on
(not for X8A-SYS or X8A-SYS-VPN).
Card guides ensure that the expansion card is reliably inserted.
➤
Push the expansion card further until it reaches the slot connector.
➤
Once the expansion card reaches the connector, lift the injector/ejector
handle until it is fixed to the cross section of the case front.
If the injector/ejector handle switch pops out, the card is plugged in correct-
ly. See also the information supplied in the
X8500
Hardware Installation
Guide.
➤
Screw the front panel of the expansion card to the
X8500
case.
The expansion card is installed.
Caution!
Forcing the expansion cards into the slots can damage the card
or slot connector.
➤
Do not force the expansion cards into the slots.
The system card (X8A-SYS or X8A-SYS-VPN) must be installed
in the system card slot (fifth slots from the left). Slots 1 to 4 and 5
to 8 are provided for the expansion cards (for numbering of slots,
see chapter "
X8500
Basic Unit" in the
X8500
Hardware Installa-
tion Guide).
For optimal performance of
X8500
, slots 5 to 8 should be fully
equipped with expansion cards before slots 1 to 4 are used!
Be sure to install a dummy front panel in any unused slot to
ensure that emissions causing electromagnetic interference are
prevented.
Summary of Contents for X5800
Page 4: ...4 BinTec Access Networks GmbH...
Page 34: ...34 BinTec Access Networks GmbH...
