It is important to limit the length of the cable on the TS1 remote, so that the bob is not
lowered into an airlock, screw conveyor or any other area that the Bob might become
trapped in. The TS1 is shipped with 30’ of cable unless otherwise specified. Disregard
these instructions if the unit was ordered with the exact amount of cable necessary for
your vessel.
1.) Remove the cable from the supply pulley by pressing the “CYCLE” button in the
center of the PC board. Keeping the cable taunt, pull on the cable as the cable spools off
the pulley. When the line is all payed out, the motor will reverse and try to rewind the
cable. Hold the cable tight so it cannot rewind. The motor should now be shut off.
2.) From the throat of the TS1, measure the height of your vessel or the maximum
distance you want the bob to travel. Cut the cable at this distance.
3.) Attach the cable to the bob as shown in the bob assembly instructions.
4.) Test the knot by pulling on the cable and bob.
5.) Rewind the cable onto the supply pulley or lower the cable and bob into the vessel.
To rewind onto the supply pulley: Pull the cable taunt. Load the supply pulley by pressing
(and hold) the “RET-LO” button located on the circuit board. Pressing this button will start
the supply pulley turning in a clockwise direction, with the cable winding over the top.
6.) Continue installation of the unit on your vessel.
Limiting the Nylon Cable Length
Jamieson Equipment Company
www.jamiesonequipment.com
toll free 800.875.0280
