BINMASTER DPM-200, Instruction Manual

Page: 17 / 46

DPM-200 Digital Panel Meter
Instruction Manual
17
Setup and Programming
This section describes how to program the DPM-200
using the front panel buttons. The DPM-200 can also
be programmed using Meterview Software as de-
scribed on page
32
, or by copying the programing
from meter to the next as described on page 31 .
• There is no need to recalibrate the meter when
first received from the factory.
•
The meter is factory calibrated prior to shipment,
for all input types, in milliamps, volts, and degrees.
The calibration equipment is certified to NIST
standards.
Overview
There are no jumpers involved in the setup process of
the meter. The RTD/TC selector switch, located
between the SIGNAL and SERIAL connectors, must
be set accordingly for the meter to accept RTD or
thermocouple inputs. See Figures under Connector
Labeling on page 11 .
Setup and programming is done through the front
panel buttons.
After power and signal connections have been
completed and verified, apply power to the meter.
For Quick Interface Reference Guide
go to page
43
.
Front Panel Buttons and Status
LED Indicators
DPM-200 Standard Display
DPM-200 X2 Display
Button
Symbol
Description LED Status
Menu
1 Alarm 1
Right arrow /
Reset
2 Alarm 2
Up arrow / Max
S*
Set point
indicator
Enter / Ack
R*
Reset point
indicator
*S and R indicators do not appear on X2 versions.
•
Press the Menu button to enter or exit the
Programming Mode at any time.
• Press the Right arrow button to move to the next
digit during digit programming.
•
Press the Up arrow button to scroll through the
menus, decimal point, or to increment the value
of a digit.
•
Press the Enter/Ack button to access a menu or
to accept a setting.
• Press the
Right
arrow and
Menu
button
simultaneously or hold the Menu button for
approximately 3 seconds to access the Advanced
Features Menu
of the meter.