Binks MX412, Quick Start Manual

Page: 4 / 16

EC Declaration of Conformity
We: ITW Finishing UK, Ringwood Rd., Bournemouth, Dorset, BH11 9LH, UK As the
manufacturer of the items listed below:
Piston Pumps MX412 MX432
Declare, under our sole responsibility, that, the equipment to which this document relates is in conformity with the following
standards or other normative documents:
EN 13463 ‐ 1:2009, EN 13463 ‐ 5:2005, EN 982:1996 + A1:2008, EN 983:1996 + A1:2008 and EN 12621:2006
And thereby conform to the protection requirements of Council Directive 98/37/EC relating to Machinery Safety Directive and
council Directive 94/9/EC relating to Equipment and Protective Systems intended for use in Potentially Explosive Atmospheres ;
CE Ex 2 II Gc T4 Issued on: 1st
July
2009 Authorized by:
Technical file lodged with; TRL Compliance Ltd
(Notified Body 0891) Moss View Nipe Lane Up
Holland WN8 9PY, UK
HAZARD
CAUSE SAFEGUARDS
EXPLOSION
STATIC ELECTRICITY Use of this
equipment in a potentially explosive
atmosphere.
Vapors from flammable liquids can
catch fire or explode from static
electricity discharges.
1. If installing this equipment in a potentially explosive atmosphere, check
the ATEX equipment category and temperature ratings meet the
requirements for the zoned area. 2. Check electrical continuity of the air
supply to earth — should be no greater than 10
6
.
3. Electrically bond all metallic equipment to earth. Should be no greater
than 1 .
SPECIAL
Over pressurization of
equipment can cause
equipment failure or injury.
Use lubricating medium
resistant to carburisation. Improper
operation or maintenance may create
a hazard. 1. Do not exceed the stated maximum working pressures
and motor speed as specified in this manual.
2. Only a suitably approved static dissipating or
conductive air supply hoses shall be attached to the
equipment and terminated to the air supply.
3. Air supplies (compressors, etc.) shall be sited in a nonhazardous area
with a filter on the air intake system to prevent the ingress of dust or similar
foreign material into the parts where compression takes place.
4. Use lubricating medium resistant to carburisation and has an auto ignition
temperature of more than 185ºC for T4 equipment.
5. User shall ensure all metallic parts of the equipment are suitably bonded
to earth. Should be no greater than 1 .
CONDITIONS
FOR SAFE USE
REQUIRED
BY ATEX
CERTIFICATION