Binks MX412, Quick Start Manual

Page: 6 / 16

6. Remove the spray tip from the gun
and point the gun into the tank. Unlock
the safety lever on the gun. Operate the
gun trigger and close the high pressure
ball valve (0114 ‐ 019091). The spray
material will now flow through the high
pressure filter, the fluid hose and the
gun, back into the tank.
7. Release the gun trigger and set
the working pressure at the
regulator.
WORK STOPPAGES
!
CAuTiO
N
If working with 2 ‐ K spray material, you
must note the given pot life and follow it
precisely. Within this time, the unit must
be carefully cleaned and rinsed with the
recommended solvent. There must be no
residue left in the pump, the high pressure
filter or the gun.
For work stoppages of between 10
and 30 minutes, please proceed as
follows:
1. Lock the safety lever on the gun.
2. Shut off the compressed air supply by
closing the ball valve.
SHUT ‐ DOWN
1. Close the ball valve for the
compressed air supply.
2. Make sure that the flow hose (0110 ‐
009103) is still directed into the spray
material tank. Carefully open the high
pressure ball valve (0114 ‐ 019091) to
reduce the pressure in the pump and in
the high pressure filter.
3. Remove the spray tip from the
gun.
CAUTION
!
If working with waterborne material, the
BINKS pump must again be thoroughly
rinsed with water before it is started up.
7. Clean the filter of the suction
system.
6. Clean the filter element of the
high pressure filter (0110 ‐ 009130).
CAUTION
!
Do not allow spray material or solvent to
soak into the ground.
CLEANING YOUR BINKS PUMP
5. Lock the safety lever on the gun.
4. Point the gun into the tank of spray
material and operate the trigger to
reduce any pressure which may still
exist in the fluid hose and in the gun.
1. Clean the pump and the suction
system from the outside. Immerse the
suction system in the tank of solvent.
2. Clean the fluid tip/tip system as
described in the service bulletin of the
spray gun. We recommend to soak the
fluid tip in solvent.
3. Unlock the safety lever of the gun
without fluid tip. Operate the gun. Close
the high pressure ball valve
(0114 ‐ 01909). Set the air inlet pressure
to 1 bar (14.5 psi) and slowly open the
ball valve. Let the solvent run through
the system so that the spraying material
can rinse out.
4. Let the solvent run through the system
for a couple of minutes until the solvent
runs clear through the gun. Close the ball
valve and lock the safety lever of the gun
5. Clean the gun from the outside
and check the filter on the handle (if
mounted).
8. We recommend keeping the
pump filled with liquid.
3. Briefly open the high pressure ball
valve (0114 ‐ 019091), taking care that
the return flow hose (0110 ‐ 009103) is
not pointed at other people or at
yourself, until the pressure has
reduced. Then close the high pressure
ball valve again.
4. Clean the outside of the spray nozzle
from spray material residue.
STARTUP AND OPERATION
6. Remove the suction system from
the spray material.
77 ‐ 2923R page
6 of 16