77-2475-R5.2 (9/2017)
11 / 12
EN
www.carlisleft.com
TROUBLE
PROBABLE CAUSE
SOLUTION
TROUBLESHOOTING
Glass wrap up.
Glass is not cut cleanly.
Motor will not run, or
lack of power.
Idler bearing does not
turn.
Cutting head does not
turn.
Deep cuts in anvil sleeve.
Bad glass pattern.
Wet glass or oil on anvil sleeve.
Material in cutter guard.
Blower control knob is shut.
Tension adjustments.
Dull or worn blades or anvil.
Dull or nicked blades.
Anvil sleeve needs replacing.
Tension adjusted incorrectly.
Blades installed incorrectly.
Rotor not centered.
Glass wrap up.
Broken vanes.
Stuck bearings.
Lack of lubrication.
Tension adjusted incorrectly.
Lack of air.
Frozen, or incorrectly adjusted.
Frozen, or incorrectly adjusted
against back plate.
Blades are in backwards.
Excessive drag.
Cutter adjusted incorrectly.
Too narrow a resin fan.
Static electricity.
Remove guard and clean out.
Open blower control knob.
Correct tension adjustment.
Replace blades or anvil.
Replace blades and anvil sleeve.
Check tensions.
Re-center rotor.
Clean out cutter.
Re-lubricate and adjust tensions.
Re-adjust tension and lubricate.
Re-adjust tension and lubricate.
Replace blades correctly.
Re-adjust tensions, and cutter.
Change spray tip angle.
Ground the system.
