77-2475-R5.2 (9/2017)
5 / 12
EN
www.carlisleft.com
Cutting Head Assembly:
The cutter comes from the factory set to cut 1" lengths, by
using four evenly spaced blades, inserted in the cutting
head (11c). You will note that there are slots every 1/2
inch. By inserting or removing the cutting blades, you can
vary the length of cut for special applications. When rein-
serting the new blades, be sure that they are on the front
side of the slot. (Refer to picture above.)
1. Insert the cutting blade (11f), then the cutting blade
spacer (11e) into the cutting head (11c). Next add the
retaining spring (11d); this is accomplished by using a
pair of needle nose pliers.
2. Then secure the above items in place by adding the
two retaining rings (11a) to the cutting head.
Final Assembly:
1. Begin by attaching the cutter bearing (16) and spacer
(10) onto the back plate (1) with a hex head screw (15)
and an eccentric nut (4).
2. Next attach the cutting head assembly (11) and spacer
(10) onto the back plate using the cutting head axle
(12) and an eccentric nut (4).
3. Now you can add the manifold assembly (6) by sliding
it into the back plate. Be sure to lubricate the three
o-rings (6f) on top of the manifold.
4. Connect the tire shaft (5c) to the air motor (5) using
the two roll pins (5d). Then attach the air motor
assembly (5) by sliding the shaft through the back
plate. In doing this make sure to line up the three air
passages with those of the manifold assembly and o-rings.
Secure the air motor assembly onto the manifold
assembly with the modified screw (7). Then secure to
the back plate by tightening the socket head screw (2).
5. To add the anvil sleeve (17) onto the air motor shaft,
you will need to apply pressure, while rotating the cut-
ting head assembly (11) at the same time. This will pre-
vent the blades from damaging the new sleeve. Replace
the retaining rings (5b) and run the motor for one min-
ute, to ensure proper break-in of the new sleeve.
6. Finally add the guard assembly (14) and the chute (13).
Binks MODEL 201-510 ROVING CUTTER
WARNING
USE CAUTION TO PREVENT ACCIDENTAL CUTS
AS THESE BLADES ARE SHARP.
!
CAUTION
DO NOT USE ANY TOOL TO FORCE THE ANVIL SLEEVE ON
THE MOTOR TIRE SHAFT. DAMAGE TO THE MOTOR CAN
OCCUR.
!
