Answering Machine
“The machine won’t
The machine’s memory may be full. You need to delete
record any
enough recorded messages to free at least one minute
messages”
recording time. Or you can delete all recorded messages
to make room for new ones
Make sure the TAM SWITCH setting is set to ON- the
icon should appear on the LCD screen.
Make sure you have not selected
ANS ONLY
on the
Answer mode setting- with
ANS ONLY
selected, callers
cannot leave messages (see page 19).
“Remote operation
Make sure you are using the correct
remote security
doesn’t work.”
pin code
.
Check that you are using a suitable tone-dialling phone.
Some cordless or mobile phones do not generate
continuous tones and so are not ideal for remote
operation.
Don’t leave more than 10 seconds between key
presses; otherwise, your call will be cut off.
Intercom and transfer (Applicable for Multi-Handset)
Make sure the other Handset is within range from the
Base unit.
Make sure you are keying in the correct number (
1
to
4
)
for the other Handset.
Batteries
Before initial use, charge the batteries
up to 15 hours
.
You may need to
replace the batteries.
Clean the battery charging contacts
with a dry cloth.
Check the connections
between the base unit and the
mains power socket.
39
Troubleshooting continue...
“I can’t transfer a
call.”
“The batteries are
running low within
an hour or two.”
“The CHARGE light
on the Base unit does
not come on.“
You need to
replace the batteries
. Please note the
following safety warnings:
Use only
rechargeable
batteries in the Handset. The
best way to make sure you get the right ones is to take
the old ones with you when you go to buy new ones.
Dispose of used batteries safely
- never burn them, or
put them where they could get punctured.
“I try to recharge
the batteries, but
I still get a warning
that they are low.”
