11
ENGLISH
Mid-sized hair-cut
(Fig. 4)
For this hair-cut, install the attachment (
7 A or B)
to the posi-
tion from 1 to 7 dependent on the area being cut
(Fig. 4a).
This
hair-cut gives a flat surface to the back of the head.
X
The most important prerequisite for each hair-cut is to properly
dry hair before cutting.
Dry the hair
against the hair growth
direction to bristle the hair
(Fig. 4b).
X
Start hair cutting from the back and sides (
Fig. 4
а
)
(ref. to the
Short hair-cut
section
).
X
To enable you to obtain a smooth finish, use the barber hair-
brush
(12)
or fingers
(Fig. 4
с
).
Remove the hair-cutting at-
tachments
(7 )
from the device. Using the barber hairbrush
(12)
or fingers, lift a small hair strand (hair should be in a
vertical position as compared to the head), move the hairbrush
(12)
or fingers along the strand length until you get the de-
sired length. The height of the cut strand is the example for the
next one. Continue cutting strand-by-strand, moving from the
back towards the forehead. Regularly comb hair to remove
cut strands and check the hair-cut results.
X
For obtaining a smooth transition area (marked with a bold line
in
Fig. 4
а
), located between the head back hair and the side
hair, slightly decline a flat hairbrush and cut-off the standing
hair (
Fig. 4d
).
X
Cut hair-cut contours and whiskers as shown in the
Short hair-cut
section.
Long hair-cut
This kind of hair-cut with hair cut off at the sides and at the back
gives long front hair.
X
Cut the back and side hair following the procedure described
in the
Short hair-cut
section
.
Cut the hair only until the bold
line in
Fig. 4
а
.
X
Starting with this level (located several centimeters above the
ear), use a flat hairbrush to obtain a smooth transition zone.
Decline the hairbrush against the head and cut off the stand-
ing hair using the hair-cutting device without any attachment
(7).
In this case the hairbrush serves as a guide
(Fig. 4d).
X
Do not cut hair from the top.
X
Cut hair-cut contours and whiskers as shown in the
Short
hair-cut
section.
X
Comb the hair as desired.
How to maintain the hair-cut
To maintain the hair-cut, from time to time trim the hair-cut
contours on the head back, whiskers and hair around the ears as
described in the
Short hair-cut
section. For this, no attachments
(
7)
is used.
Beard cutting
X
Start cutting the beard under the chin. Move the device sym-
metrically either to one side, or to the other (
Fig.5
).
X
Hair out of the beard contour should be cut with an upturned
device, with no tip attached. Cut hair in short careful moves.
