Binatone AQUAREL XDC1520, Instruction Manual

Page: 29 / 130

ENGLISH
29
Note: If you do not switch off the handset locator function, then 30 seconds
later this function will be switched off automatically.
Clock
To set the time on the clock
1. With the telephone in the standby mode, press the MENU button [3] .
2. By pressing the button [5], select the ADDITIONAL FUNCTION menu item,
after that press OK [3] .
3. By pressing the button [5], select the CLOCK menu item, then press OK [3] .
4. By pressing the or button [5] , select the ON or OFF menu items.
5. If you chose ON , move to step 6.
6. By pressing the or button [5] , set the correct hour. Then press the
button [5] .
7. By pressing the or button [5] , set the correct minutes. If you set the 12-
hour format, then move to step 6. If you set the 24-hour format, move to step 8.
8. Press the button [5] .
9. By pressing the or button [5] , select ÀÌ or ÐÌ .
10.Press OK [3] to confirm.
To stop the clock
1. To stop the activated clock, press the STOP button [4] .
2. You can also delay the activation time by 10 minutes by pressing the LATER
button [3] .
Note: If the clock becomes activated when you pressed no buttons during 1
minute, then it will automatically become activated again in 10
minutes.
Monitoring
This function allows you to listen to what is going on in the next room. Most often
this function is used to keep an eye on babies. To use this function, you need to have
two handsets registered at the base unit.
Start of monitoring
Handset 1
1. With the telephone in the standby mode, press the MENU button [3] .