5.8G Bridge
ETH/ POE interface: This is a data transmission port, and it is also a
power port. When the device works in the bridge mode, the interface acts
as a LAN port function. When the device works in the route mode, the
interface acts as a WAN port function. This interface is used to connect
the POE interface to the POE power.
COM: It is a debugging interface.
Signal indicator:
Master AP:
Output power indicator lamp.
When the output power is less than 17dbm, the SIG1 light lit, the
output power is between 17~19dbm, the SIG1-SIG2 lights lit, the
output power is between 20~22dbm, the SIG1-SIG3 lights lit, the
output power is at 23dbm and above, the SIG1 to SIG4 lights lit.
Subordinate AP:
Signal connection intensity indicator
Running flowing water light when connection fails.
When the connection is successful and the signal intensity in the
range of 0~-65dbm, the SIG1 to SIG4 lights lit, the signal
intensity in the -66~-75dbm, the SIG1 to SIG3 lights lit, the
signal intensity in -76~-85dbm, the SIG1 to SIG2 lights lit, the
signal intensity in the -85dnm and below, the SIG1 light lit.
2 - English
The lights flicker when the bridge is running normally.
Power indicator lamp When the power is electrified, the lamp is
always bright and goes out when it is broken.
Digital tube indicator lamp Short press "digital switch / reset"
button, each digital tube value will add one (0-9-A-F cycle).
Port state indicator lamp
：
When the wire is connected, it is
always bright and goes out when it is broken
Indicator light state description
2
.
4G Bridge
