b. Connect the DC power supply to the driver -- Do not
apply power
I. Make sure the power supply is not on. Connect V+ and V- from the
power supply to the V+ and V- terminals of your driver.
II. Ensure a proper earth ground connection by
using the screw on the left side of the chassis.
If using an external fuse, we recommend the
following in-line with the V+ connection:
DRV-4: 3AG, 4 amp (Littlefuse 313004P)
DRV-8: 3AG, 6.25 amp (Littlefuse 3136.25P)
c. Connect the motor to the driver
blk/wht
blac
k+org/wht
red+y
el/wht
yello
w+red/wht
A+ A- B+ B-
Connect OLE eight lead motors in parallel, as shown below. If using a motor
from another source, please refer to your motor specs for wiring information.
A motor wiring diagram is shown in Figure 1.
!
Warnings:
• Do not install where ambient air is more than 104° F.
• Do not install where there is no air flow
• Do not install where drive can get wet.
• Do not install where electrically conductive material can fall on
the driver.
• Drives must be mounted at least one-half inch apart.
!
Warning: Observe proper polarity when connecting wires.
!
Warning: Never connect or disconnect the motor when power is
applied.
7
