E4-WM5-Y630A00
MOUNTING INSTRUCTION
created: 04.16.19 E4-WM5-Y630A00_2 Page 18 of 22 latest revision: 09.29.20
II.
Place the entire reservoir/bracket assembly shown above under the rear quarter panel and mount to the two holes in
the frame. If threaded holes exist, apply non-permanent thread locker to two of the Flange Head Cap Screws
(BOM item #15) and use a 13mm wrench to mount the assembly to the frame. If Threaded Inserts were installed,
apply non-permanent thread locker to two of the Hex Head Cap Screws (BOM item #16) and use two of the Washers
(BOM item #2) and a 7/16” wrench to mount the assembly to the frame. Now, slide the reservoir back until there is
approximately 1/4” clearance to the body mount bracket.
Torque both Flange Head Cap Screws to 18 ft-lb (25 Nm)
OR both Hex Head Cap Screws to 14 ft-lb (19 Nm).
JJ.
Once the reservoir has been positioned as shown and confirmed to not be contacting anything on the vehicle, tighten
the Socket Head Cap Screw that was snugged down in step HH.
Torque the Socket Head Cap Screw to 6 ft-lb (8 Nm).
