E4-WM5-Y630A00
MOUNTING INSTRUCTION
created: 04.16.19 E4-WM5-Y630A00_2 Page 16 of 22 latest revision: 09.29.20
CC.
Slide the reservoir through the Reservoir Clamp as shown below. Snug up the Socket Head Cap Screw
(BOM item #14) so that the reservoir bracket assembly doesn’t fall off the reservoir. But leave loose enough to be able
to slide the reservoir back and forth in the Reservoir Clamp.
Front side
Back side
DD.
Place the entire reservoir/bracket assembly shown above under the rear quarter panel and mount to the two holes in
the frame. If threaded holes exist, apply non-permanent thread locker to two of the Flange Head Cap Screws
(BOM item #15) and use a 13mm wrench to mount the assembly to the frame. If Threaded Inserts were installed,
apply non-permanent thread locker to two of the Hex Head Cap Screws (BOM item #16) and use two of the Washers
(BOM item #2) and a 7/16” wrench to mount the assembly to the frame. Now, slide the reservoir back until there is
approximately 1/4” clearance to the exhaust hanger bracket. This should yield more than 1/4” clearance to the fender
on the front side.
Torque both Flange Head Cap Screws to 18 ft-lb (25 Nm)
OR both Hex Head Cap Screws to 14 ft-lb (19 Nm).
EE.
Once the reservoir has been positioned as shown and confirmed to not be contacting anything on the vehicle, tighten
the Socket Head Cap Screw that was snugged down in step CC.
Torque the Socket Head Cap Screw to 6 ft-lb (8 Nm).
Depicted above with Hex Head Cap Screws and Washers (Threaded Inserts were used)
