Part No 442503
Form No F081512A
8
Z FORCE BLOWER Owner’s Manual
ASSEMBLY
Figure A
Figure B
Proper mounting Improper mounting
Wires tied down
Wires not tied down
1
.Follow the steps in figures A and B, then securely tighten all hardware shown.
2
.Connect spark plug wire on the blower.
Make sure your JRCO bar is attached to your mower.
Then replace the mounting bracket with the bracket
provided (item 4). Attach the Blower to brackets and
install the pins making sure they are completely pushed
in. NOTE some JRCO bars will require mounting to the
outside ears of the blower bracket (15” Center).
Ensure the unit is mounted level, failure to do so may
result in poor handling and will put stress on the blower
frame. Level the unit by adjusting the mounting brackets
(item 4) up or down depending on your mower.
Connect the rear portion of the wiring harness to the
mower battery by attaching the red wire to the positive
terminal and the black wire to the negative terminal.
Route the harness so that the connector is located at the
foot rest portion of the mower.
Note
make sure the
position of the switch box will not interfere with mower
operation controls. Secure any excess length of wire to
the frame of the mower using ty wraps. FAILURE TO
CONTAIN EXCESS WIRE WILL RESULT IN WIRE
COMING INTO CONTACT WITH MOVING PARTS ON
MOWER (belts, blades, brake pedals, etc.) FAILURE TO
PROPERLY SECURE WIRING HARNESS WILL
RESULT IN FAILURE AND IS NOT COVERED UNDER
WARRANTY!
