Billion BiPAC 4700AZ, User Manual

Page: 14 / 189

10
3
SIM Card Slot
Insert the mini SIM card (2FF) with the gold contact facing down.
Push the mini SIM card (2FF) inwards to eject it
Warning: Before inserting or removing the SIM card, you must disconnect the
router from the power adapter.
4 WiFi LED for 2.4G
The single-colour LED behaves as follows:
Green Wireless connection established
Green blinking Data being transmitted / received
5 WiFi LED for 5G
The single-colour LED behaves as follows:
Green Wireless connection established
Green blinking Data being transmitted / received
6
LTE LED
(Received Signal
Strength Indicator)
The 4G/LTE received signal dual-colar LED behaves as shown below.
Green RSSI greater than -69 dBm. Excellent signal condition
Green Flashing quickly RSSI from -81 to -69 dBm. Good signal condition
Orange Flashing quickly RSSI from -99 to -81 dBm. Fair signal condition.
Orange Flashing slowly RSSI less than -99 dBm. Poor signal condition.
Orange No signal and the 4G LTE module is in service
Off No LTE module or LTE module fails
7 Power LED
The Power dual-colour LED behaves as shown below.
Green System is up and ready
Red Boot failure
8 Internet LED
The Internet dual-colar LED behaves as shown below.
Green IP connected and traffic is passing through the device.
Red IP request failed.
Off Either in bridged mode or WAN connection not present.
9 Gigabit Ethernet WAN
Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one of the four LAN ports when
connecting to a PC or an office/home network of 10Mbps/ 100Mbps/ 1000Mbps.
Note: The EWAN port is a configurable LAN/WAN port, which automatically
becomes an EWAN port when EWAN internet interface is being selected in the
GUI
.
10 LAN (PoE interface)
The PoE interface, pleae connect to supplied 802.3at PoE- equipped switch or power
injector.
11 Ethernet LED
The dual-colour LED behaves as shown below.
Green Transmission speed is at Gigabit speed (1000Mbps)
Orange Transmission speed is at 10/100Mbps
Blinking Data being transmitted/received