1
Epoxy the pivot & round hinges to the rudder.
Assemble the rudder steering arm to the tair fuselage
as illustration.
Epoxy the rudder to the vertical fin.
The sketch map of the steel wires work for the rudder.
Epoxy the ply plate to the position to fix the rudder steering arm.
Make sure hinges are
mounted in the same line.
3
pivot & round hinge(5x68mm)
3
pivot & round hinge(5x68mm)
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
4
Steel wire (0.5x3000mm)
1
Rudder steering arm(3mm)
1
Ply plate (3mm)
1
Ply plate (6mm)
Steel wire (0.5x3000mm)
2
Steel wire (0.5x3000mm)
2
1
1
Rod (2x200mm)
Retainer
Ply plate (6mm)
4
TP Screw (2.3x12mm)
6
TP Screw (2.3x8mm)
Rudder steering arm(3mm)
Rudder steering arm(3mm)
5
4
4
Clevis
Copper joiner
Aluminum tube(3x6mm)
5
5
Screw (2x10mm)
Nut (2mm )
28
29
30
32
6
31
Accessory list for the coming installation steps.
Assemble the tail wheel cover to the fuselage with TP screws.
The picture of the tail wheel cover.
Assemble the tail landing gear to the fuselage as show
in figure below.
The picture of the tail landing gear after the servo
install completion.
Steel wire (0.5x3000mm)
1
Clevis(2mm)
1
1
Rod (2x200mm)
Retainer
1
Lock Nut (2mm )
1
Screw (2x12mm)
4
4
4
Clevis
Copper joiner
Aluminum tube(3x6mm)
4
4
Screw (2x12mm)
Nut (2mm )
Steel wire
Copper joiner
Aluminum tube
Lock Nut (2mm )
Screw (2x12mm)
Ball joint
Install the control horn and connect the linkage of the
rudder servo.
Connect the steel wires of the rudder horn and
tail gear to the servo.
2
Steel wire (0.5x3000mm)
4
TP Screw (2.3x12mm)
TP Screw (2.3x12mm)
6
TP Screw (2.3x8mm)
1.5mm
1
Ply plate (3mm)
Ply plate (3mm)
35mm
29.5mm
35
36
37
38
7
34
33
