Electric retract system
Receiver
7.4V 30C
For retracts
4.8V
For receiver
In order to let the customers have
more choices, we don't provide a
uniform plugs.
4
.
Assemble the electric retracts to the plane
after several times smoothly running.
Please don't ceaselessly turn and off the switch in 2 seconds,
if you do this way, the circuit board will be heated.
Thank you very much for purchasing our TRCM optional electric retract set,
all our products were passed strict QC before they shipped out to the customers.
In order to avoid probably trouble happen, we still would like you to follow the steps
below before you assemble our electric retracts to your plane.
1
. Connecting the circuit board to the battery and receiver.
2
.
Turn on the radio control to check the lights
on the circuit board, if the lights turn on green
or turn on red orderly
，
0.5 second after each
from the right to the left and all the lights will
turn off after 15 seconds, then the circuit will
work normally. Otherwise the circuit will be a
defective one if you make sure the setting on
your radio control are correct, please don't use
it but contact with your supplier in time.
3
.
Link the electric retract units to the
circuit boards after the above two
steps, check again the electric retracts
to see if they can work normally or not.
1
1mm
Aileron
Trailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Make sure they are in
the right position while
installing.
Keep some space about 1mm width between the
trailing edge and the aileron.
Ball joint
Ball joint
Lock Nut (2mm )
Lock Nut (2mm )
Screw (2x12mm)
Screw (2x12mm)
8
Screw (3x6mm)
16
8
8
Screw (2x12mm)
Nut (2mm )
Horn
4
Screw (3x6mm)
L bracket
L bracket
Push rod
（
2mm)
Install the L brackets to the servo of ailerons and flaps
as illustration below.
Install the nylon control horn and connect the linkage.
Apply instand type AB glue to the holes in the ailerons,
flaps and hinges.
Horn
4
Horn
4
4
Servo tray(68.5x56.5x2mm)
Pivot & round hinge(5x68mm)
8
8
Clevis
（
2mm)
8
8
Screw (2x12mm)
8
Screw (3x6mm)
Locknut (2mm )
2
Push rod
（
115x2mm)
2
Push rod
（
138x2mm)
16
Horn
4
8
L bracket
Screw (3x10mm)
2
Main wing joiner(30x415mm)
2
Main wing joiner(20x227mm)
16
TP Screw (2.3x12mm)
Flap
1mm
Make sure they are in
the right position while
installing.
Trailing
edge
Keep some space about 1mm width between
trailing edge and flap.
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
6
Pin hinge(24x24mm)
Pivot & round hinge(5x68mm)
8
Pivot & round hinge(5x68mm)
6
Pin hinge(24x24mm)
1
2
3
4
5
1
Accessory list for the coming installation steps.
