36.
USING A PHILLIPS SCREWDRIVER REMOVE THE FOUR SCREWS SHOWN ON
FIG. 26
. NOTE: THE TWO FRONT SCREWS ARE LONGER THAN THE OTHER
TWO SCREWS.
37.
CAREFULLY REMOVE THE LEFT AND RIGHT CONSOLE SIDE PANELS BY PULLING THEM STRAIGHT OUT.
38.
ON THE TOP SIDE OF THE CONTROL PANEL REMOVE THE TWO PHILLIPS SCREWS SHOWN IN
FIG. 27
. LIFT THE CONSOLE BEZEL UP FROM THE REAR
AND PUSH IT FORWARD AND REMOVE IT.
39.
REMOVE THE CENTER PHILLIPS SCREW SHOWN IN
FIG. 28
. LIFT STRAIGHT UP ON THE CENTER SWITCH COVER AND REMOVE IT. SCREW AND COVER
WILL NOT BE REUSED.
40.
INSTALL THE SUPPLIED SWITCH BUTTON INTO THE PANEL BY SIMPLY LINING UP THE SLIDES AND PUSHING THE SWITCH INTO PLACE.
41.
REASSEMBLE THE BIKE IN REVERSE ORDER EXCEPT FOR THE FOG LIGHT COWLS.
42.
WITH THE BIKE ON ITS CENTER STAND OR HAVING SOMEONE HOLDING IT LEVEL SET THE AIM OF BOTH FOG LIGHTS TO YOUR DESIRED POSITION.
LOOSEN THE ADJUSTMENT BOLT (
FIG. 12
) TO MOVE THEM AS NEEDED AND THEN RETIGHTEN.
43.
REMOVE THE AREA SHOWN IN
FIG. 29
ON BOTH THE RIGHT AND LEFT FOG LIGHT COWLS. USE A HACKSAW BLADE TO CUT EACH TAB. THEN USE A
SMALL FILE TO CLEAN UP THE EDGES.
44.
REINSTALL BOTH FOG LIGHT COWLS.
ALTERNATE CONSOLE ACCESS:
1.
PLACE A PIECE OF MASKING TAPE ON EACH SIDE OF THE CONSOLE AS SHOWN IN
FIG. 13A
. SLIDE THE TAPE UNDER THE EDGES OF THE SHELTER AS
SHOWN IN
FIG 13A
. REMOVE THE 2 PLASTIC RIVETS SHOWN IN
FIG 13A
.
2.
CAREFULLY LIFT THE FRONT EDGE OF THE SHELTER AS SHOWN IN
FIG. 14A
. THERE IS A TAB THAT WILL RELEASE FROM BELOW. REPEAT ON LEFT
SIDE OF CONSOLE.
3.
USING A “L” STYLE 5MM ALLEN WRENCH REMOVE THE TWO SCREWS UNDER THE SHELTER. SEE
FIG. 14A
AND
FIG. 15A
.
4.
USING A NEEDLE NOSE PLIERS REMOVE THE PLASTIC RIVET SHOWN IN
FIG. 16A
. REPEAT ON THE LEFT SIDE RIVET.
5.
SLIDE THE CONSOLE FORWARD AND LIFT THE FRONT. FLIP IT UP AS SHOWN IN
FIG. 17A
. FROM HERE GO TO
STEP 36
TO COMPLETE INSTALLATION.
PAGE 2