BIG BALE Transtacker 4100, Operation And Maintenance Manual

Page: 38 / 88

'Settings' is the only page that contains settings
that can be edited
(
Fig. 1 4 1 )
. The recommended
Angle and Timers are as followed.
Pickup Release Angle - 177
o
Turntable Release Angle - 88 o
Bed Full Continue Timer - 300ms
To change edit these 'Settings':
1.
2.
Buttons 'B' refers to 'Pickup Release Angle', 'C'
refers to 'Turntable Release Angle' and 'D' refers to
'Bed Full Continue Timer'
(
Fig. 1 4 1
).
Once the desired setting is selected, use the up
and down arrows to change the value
(
Fig. 1 4 1
).
3. To save these 'Settings' press the 'O'.
4. To cancel these 'Settings' press the 'X'.
Fig. 1 4 1
C
D
B
7 .0 Diagnostics / Settings
7. 5 Settings Page 1 - Rotary Transducers Address
Fig. 13 7
Fig. 13 8
Fig. 13 9
Fig. 1 40
7. 6 Settings Page 2 - Valve Demand Rates
7. 7 Settings Page 3 - Demand/Angle Curves
7. 8 Settings Page 4 - Pressure Transducer Address
7. 9 Settings Page 5 - Settings
This page shows you the current address each Rotary
Sensor has been assigned (
Fig. 13 7 ). You will only
need this page is guided to it. Below is the standard
address which have been assigned from factory.
Raise Pickup - 213
Raise Turntable - 217
Rotate Turntable - 211
Valve Demands shows the rate at which each function
can be operated in manual mode ( Fig. 13 8 ). Each
rate can be between 0-250 however you won't see a
hydraulic affect unless its between 140-250. Full flow
being 250.
On the rotate functions, there are 3 positions where you
can control the speed ( Fig. 13 9 ). This can only be
altered by a service engineering. For an example, on
the Pickup Raise from 0-90 degrees the rate is full flow
(250). When it gets near 180 degrees it will slow the rate
down to 180. This is to increase the longevity of the
machine.
This page shows you the current address each Pressure
Sensor has been assigned ( Fig. 1 40 ). You will only
need this page i f guided to it.
35