WWW.BIGASSFANS.COM © 2015 DELTA T LLC ALL RIGHTS RESERVED.
9
5. Install junction box
1. Remove the cover from the junction box, and then secure the junction box to the fan brace with the Junction
Box Hardware.
Note: Install the junction box on the yoke side of the fan closest to the supports.
2. Route and install the provided corrugated conduit and enclosed wiring from the junction box to the speed
control junction box (on the fan). Press the conduit into the connectors.
3. Route the oscillator cord to the junction box and secure it to the designated connector.
Note: It is critical that
the fan orientation and angle is set before routing the cord.
4. Install the cord grip connector and power cord (previously removed from original speed control) in the open 1/2”
connector hole on the junction box.
5. Strip 5” of outer jacket off of the remote speed control cables. Install the cables in the (2) cord grip connectors
for the Speed Knob and the On/Off Switch.
Junction Box Hardware:
a. (2) 8-18 x 1/2” Hex Head Self-drilling Screw
Speed
Knob
On/Off Switch
Original
Speed
Control
Oscillator
Cord Grip
Connector &
Fan Power Cord
Junction
Box
Junction
Box
Cover
a
Note: The mounting method or fan orientation may
differ from the illustration above.
Corrugated Conduit
(Remote Speed Control)
ATTENTION
Big Ass Fans does not supply the cable needed to install the oscillator On/Off switch.
