WWW.BIGASSFANS.COM © 2015 DELTA T LLC ALL RIGHTS RESERVED.
1
(8) 3/8” Washer
Cord Grip Connector
Oscillator Assembly
Speed Control
Cover
Handle
(8) 3/8-16 x 3/4”
Hex Head Cap
Screw
(3) Yellow Wire Nut
PORTABLE BASE OSCILLATOR INSTALLATION
The following instructions are for installing the Oscillator accessory on a Yellow Jacket
®
fan that is mounted to
a portable base. Consult the complete Yellow Jacket Installation Guide for all other aspects of fan installation,
operation, and safety information.
WARNING: Disconnect the fan from power before installation!
WARNING: Do not prevent the oscillator from rotating when in operation!
Parts and hardware
The parts and hardware listed below are intended for the oscillator option on a Yellow Jacket with a portable base
mount. For a complete list of fan components, see the Yellow Jacket Installation Guide. If you are missing any parts
or hardware required for installation, contact Customer Service.
Note: The illustrations below are not to scale.
Installation
If you are installing the oscillator on a previously assembled fan with a portable base and one (1) pedestal, first
remove the (4) bolts, (8) washers, (4) nuts, and fan yoke assembly from the pedestal. Discard the used hardware.
If you are installing the oscillator on a previously assembled fan with a portable base and two (2) pedestals, first
remove the (4) bolts, (8) washers, (4) nuts, and fan yoke assembly from the upper pedestal. Discard the used
hardware. Next, remove the (4) bolts, (8) washers, and (4) nuts (Pedestal Hardware) and the upper pedestal from
the lower pedestal. Set the Pedestal Hardware aside. You will use it to reattach the upper pedestal and handle to
the lower pedestal.
1. Assemble portable base
In the complete Yellow Jacket Installation Guide, follow the steps
under “Mounting Method: Portable Base” to secure the wheels
and pedestal. If you are installing two pedestals, do not attach
the second pedestal yet.
Attach Wheels (to Portable Base)
Attach Pedestal (to Portable Base)