December 2020
Installation, Operation and Maintenance Manual
MAN 606 Rev. 5
Operation and Use
20
Section 3: Operation and Use
For the adjustment of the mechanical stop on the end flange of cylinder, follow these steps
(Figure 18):
•
Remove with the specific wrench (c1) the plug (t).
•
Insert a wrench for Allen keys (c2) in the through hole until reaching the
adjustment pin (g).
•
Keep the protection cover blocked with the special wrench (c3).
•
Turn counterclockwise to increase the angular stroke, turn clockwise to decrease it.
•
When the adjustment is over tighten the plug (t).
In case of an actuator with two cylinders (Figure 18), both mechanical stops are screwed on
the end flanges of the cylinders.
Figure 18
Actuator with two cylinders
