BIC WINDSURF
FOIL
USER MANUAL
ASSEMBLY
PRIOR TO ASSEMBLY
Double check the state of all components of your Windsurf Foil prior to every use. The Foil’s
mast, body and both wings should be smooth and free of sharp cutting edges that can
cause serious injury to either you or somebody else. All components should be free of any
blemishes or stress fractures that may show signs of excessive wear and tear. The screws
should be in good condition and free of any corrosion. All components should be clean of
sand, dirt or grit prior to assembly. If you have any doubt as to the state of your Windsurf Foil,
do not use it and contact your point of purchase for further information.
ASSEMBLY INSTRUCTIONS
FRONT WING
1. Place the board on the ground, deck
down, on a protected surface (board bag,
grass, sand… etc.).
2. Insert the head of the foil into the fin box
so that the foil is held firmly in place. At
this stage no need to insert the foil fully
into the board.
3. Place the front wing on the body, so that
it fits snugly in the front insert. Line up the
screw holes on the wing with the inserts
on the body, and gently hand tighten the
screws.
Attention : All Foil Assembly screws are the
same size except one, and this largest Foil
Assembly Screw is for the middle of the
front wing.
