
22
Adjust set point
If the SET button is pressed and held
for a few seconds the Adjust Set point
LED illuminates. Then using just the
UP or DOWN ARROW adjust the Set
temperature.
speed of Change of set Temperature
Each press of the UP ARROW or DOWN
ARROW buttons will increase or decrease
the set temperature by 0.1°C. If the
buttons are held down the temperature
change will accelerate to 5°C per second.
Once adjustment has been made and
following approximately 3 seconds the
Adjust Set Point LED goes out and the
unit returns to display the current block
temperature. The unit will then heat to the
Set point.
display units setting °C or °f
Press the set button 5 times and hold for a
few seconds which will display U C or U F.
Then use either the UP ARROW or DOWN
ARROW buttons to select either °C or °F.
The unit will return to the current block
temperature display after a few seconds in
the selected units.
heater LEd
When the set temperature is higher than
the block temperature this indicator will
light. If the light is on continuously the
block is getting constant power. The only
exception is described in the section on the
over-temperature cut-out operation. As
the block temperature approaches the set
point temperature the heater indicator will
flash. When set temperature is reached the
indicator will stay on for shorter periods.
set
Test
35000
Adjust (Set point)
set
Test
set
Test
70000
Heater On
U C