9
AudiaFUSION REAR PANEl
Channel-to-Channel Failover
In addition to entire amplifier failover, AudiaFUSION supports channel-to-channel failover, which is triggered by one of the following conditions:
Heat Sink alarm
•
Short Circuit alarm*
•
Channel Failure alarm
•
The wire failover link cable is not required when wiring channel-to-channel failover.
The redundant channel can be wired in parallel to the existing speaker line (shown above) or connected to a redundant speaker line.
The primary amplifier module will resume control after the fault condition is cleared and the unit is re-powered.
OUTPUT
Class 2 Wiring
AM-600
OUTPUT
Class 2 Wiring
AM-600
1
2
OUTPUT
Class 2 Wiring
AM-600
OUTPUT
Class 2 Wiring
AM-600
1
2
Primary
Redundant
Redundant Wiring
Parallel Wiring
* A Short Circuit alarm will cause failover only if the Persistent Short Circuit Delay time property in the AudiaFUSION is exceeded.
Summary of Contents for AUDIAFUSION
Page 2: ...IMPORTANT SAFETY INSTRUCTIONS ...
Page 16: ...15 15 compliance ...
Page 17: ...16 IMPORTANT SAFETY INSTRUCTIONS ...